Beltronics Radar Forum  

Go Back   Beltronics Radar Forum > Custom Installed Detectors > STi-R & STi-R Plus Remote

Notices

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #1  
Old August 26th, 2017
kathysrazor kathysrazor is offline
Junior Member
 
Join Date: Aug 2017
Posts: 1
Unhappy Dead after upgrade

I ran an update on my STIR+ through Detector Tools, and now the unit won't display anything.

I am still able to enter the update mode by holding down Power and Mute. When I try to re-update using Detector Tools, it tells me to cycle the ignition and wait for it to show the device is connected. I do so, and it shows up as connected, but when I click OK, nothing happens. The "Update Detector" dialog just shows up again.

I know that I'm able to enter the update mode - it shows up in device manager as a USB HID vendor-defined device. Detector tools is able to read the serial number, and the keypad glows red (so I know that it's reading the keypad input).

Do I have to have an active subscription in order to do a device update, rather than a map update?
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:17 AM.

Contact Us - Beltronics - Archive - 39 40 41 Terms of Service - 42 Top
Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2018 Beltronics
Valid XHTML 1.0 Transitional Valid CSS!